Engineering, 05.05.2020 06:56, ashleygervelus
Design a complete analog system for the following scenario. Draw the required analog circuitry (you can draw the circuit schematics, or block diagrams, or use a combination). You don't have to compute the specific component values, but state what function each block performs (with relevant equations if opplicable) and what the parameters are (or how you would choose them.
You have three piezoelectric force sensors; each of them output a voltage that is a linear function of the force applied. For the first and third sensor, the output voltage varies from 0 to 3 V when 0 to 10 N force is applied. The second sensor produces 5 to 10 V when 0 to 20 N force is applied. When the total force sensed by the first two sensors is more than the force sensed by the third sensor, an LED will light up (with a fixed brightness).
Modify the system in above problem as follows. The LED will light up when the average force sensed by the first two sensors is within t1 N of the force detected by the third sensor.
Answers: 1
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, lerasteidl
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10, Larkinlover703
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
Design a complete analog system for the following scenario. Draw the required analog circuitry (you...
Mathematics, 01.11.2020 01:30
Mathematics, 01.11.2020 01:30
History, 01.11.2020 01:30