Engineering
Engineering, 05.05.2020 04:26, bryan519688

The undisturbed soil at given borrow pit is found to have the following property:
w = 15%; y = 19.1 kN/m^3; Gs = 270
The soil from this borrow pit is to be used to construct a rolled fill having a finished volume of 38, 500 m^3. The soil is excavated by means of a shovel and dumped onto trucks saving a capacity of 4 00 m^3 each. When loaded to capacity, these trucks are found to contain, on the average, a net weight of toil and water equal to 72.7 kN
In the construction process. the trucks dump their load on the fill and the materials spread and broken up, after which a sprinkler adds water until the moisture content is equal to 18%. The soil and water are thoroughly mixed by a disc (or similar equipment) and then compacted until the dry unit weight is equal to 17.3 kN/m^3.
1. Assuming that each load is a full capacity load, how many truckloads are required to construct the fill?
2. How many liters of water will have to be added per truck load, assuming that the moisture tots by evaporation during excavation, haulage, and handling it negligible?

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, mirmir62
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
image
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
image
Engineering, 06.07.2019 03:20, mardell2587
Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing
Answers: 3
image
Engineering, 06.07.2019 03:30, relic7391
The load on a bolt consists of an axial pull of 10 kn together with a transverse shear force of 5 kn. the bolt material has a yield strength of syt syc 100 mpa. find the diameter of the bolt at factor of safety n-0.5, n 1 and n-2 using maximum shear stress theory
Answers: 3
Do you know the correct answer?
The undisturbed soil at given borrow pit is found to have the following property:
w = 15%; y...

Questions in other subjects: