Engineering, 05.05.2020 03:57, Annapetrik

A two-stage turbine system, with reheat between the stages. The first turbine inlet is at 560 °C and 160 bar. Reheat occurs at 40.0 bar up to 560 °C. The second-stage turbine outlet is 2.00 bar. (b) Cooling at constant pressure in a condenser via heat exchange with ambient air to saturated liquid. The air used in condenser cooling must not exceed 400 K when it is released from the power plant. (c) A pump from the low-side pressure to the high-side pressure. (d) Heating in a boiler at constant pressure, using the waste heat from the Brayton Cycle in a first stage and natural gas combustion in a second stage to reach the turbine inlet temperatures. Turbine reheat occurs in the second stage

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, abdirahmansoloman

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

continue

Engineering, 04.07.2019 19:10, moneyyfletcher

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

continue

Engineering, 04.07.2019 19:10, Lexi5170

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b. s. and b. s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

continue

Engineering, 04.07.2019 19:20, holaadios222lol

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

continue

Do you know the correct answer?

A two-stage turbine system, with reheat between the stages. The first turbine inlet is at 560 °C and...