Engineering
Engineering, 05.05.2020 05:32, seasmarie75

The moisture in hot, humid, stagnant air surrounding a cold water pipeline continually diffuses to the cold surface where it condenses. The condensed water forms a liquid film around the pipe, and then continuously drips off the pipe to the ground below. At a distance of 10 cm from the surface of the pipe, the moisture content of the air is constant. Close to the pipe, the moisture content approaches the vapor pressure of water evaluated at the temperature of the pipe.

a) Draw a picture of the physical system and state at least five reasonable assumptions for the mass transfer aspects of the process.

b) What coordinate system should be used? b) What is the simplified differential form of Fick's equation for water vapor (spech

c) What is the simplified form of the general differential equation for mass transfer in terms of flux NA? What term is constant over the diffusion path?

d) What is the general differential equation for mass transfer in terms of concentr Propose two boundary conditions that may be used to solve the resulting differential equation.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, maciemarklin79981
A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?
Answers: 3
image
Engineering, 04.07.2019 19:10, pjgolden04
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
image
Engineering, 04.07.2019 19:10, Mimidj9279
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
image
Engineering, 04.07.2019 19:10, rhiannpelham60
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
Do you know the correct answer?
The moisture in hot, humid, stagnant air surrounding a cold water pipeline continually diffuses to t...

Questions in other subjects: