Engineering
Engineering, 05.05.2020 07:23, edjiejwi

A commercial enclosed gear drive consists of a 20° spur pinion having 16 teeth driving a 48-tooth gear. The gears are straddle-mounted with bearings immediately adjacent. The pinion speed is 300 rev/min, the face width 2 in, and the diametral pitch 6 teeth/in. The gears are grade 1 steel, through-hardened at 200 Brinell, made to No. 6 quality standards, uncrowned, and are to be accurately and rigidly mounted. Assume a pinion life of 108 cycles and a reliability of 0.90, and use YN=1.3558N-0.0178, ZN=1.4488N-0.023. The power is 5hp. (Assume uniform loading, constant thickness gears).a. Find the AGMA factor of safety for bending for the pinion. b.Which of the AGMA terms used in part (a) will be different for the gear? No need to calculate them, just list the terms that would differ between pinion and gear.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, aliceohern
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
image
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
image
Engineering, 04.07.2019 19:10, rayne40
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
Do you know the correct answer?
A commercial enclosed gear drive consists of a 20° spur pinion having 16 teeth driving a 48-tooth ge...

Questions in other subjects:

Konu
Mathematics, 19.03.2021 20:00
Konu
Mathematics, 19.03.2021 20:00