Engineering, 05.05.2020 07:30, PaMuth1100

The production of X3 d foil used in printed circuit boards is accomplished by an electroforming operation in which a slowly rotating titanium drum acts as the cathode to plate copper onto its surface. The drum diameter = 500 mm and its width = 300 mm. At any moment during the process, 40% of the drum’s circumferential surface area is submerged in the electrolytic bath (the ends of the drum are insulated to prevent plating). As the copper foil exits the bath, it is peeled from the drum surface. If the thickness of the foil = 0.05 mm on the drum surface when it is peeled, and the process operates at a current of 500 amps. Determine the rotational speed of the drum

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

Do you know the correct answer?

The production of X3 d foil used in printed circuit boards is accomplished by an electroforming oper...