Engineering
Engineering, 05.05.2020 08:19, asialoggin21

A four-pole induction machine with following parameters is controlled in the rotor flux linkage-oriented vector control mode by a PWM inverter with an ideal current regulation loop. The machine is running in the steady state, ieds= 7 A. The frequency of the stator current is 55 Hz. At t = 0 s, when the direction of the rotor flux linkage coincides with that of the magnetic axis of the "a"-phase winding, the input contactor of the machine is opened as shown in figure below. After t=0+, find the line-to line voltage between the "a" and "b" phase of the machine by using the following procedures. The current to the machine is immediately zero after the opening of the contactor.

Rs= 0.55Ω
Rr= 0.36Ω
Lls= 1.8mH
Llr= 1.8mH
Lm=59mH
Jm= 0.04kg. m^2

The rated power of the induction machine is 5Hp, and the inertia of the load is nine times the machine inertia, JM. And the friction coefficient, BM+L, of the drive system is 0.1 N-m/(rad/s).

a. Just after the opening of the contactor, find the rotor angular speed, ωr (0+), and the d-q axis stator flux.
linkage, λrds(0+) and λrqs(0+) in the rotor reference frame.

b. Find the rotor angular speed, ωr (t), t > 0+, in electric angle.
c. Find the "a" phase voltage, Vas(t), t > 0+
d. Find the "b" phase voltage, Vbs(t), t > 0+
e. Find line-to-line voltage, Vab(t), t > 0+

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, lerasteidl
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
image
Engineering, 04.07.2019 18:10, johnthienann58
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
image
Engineering, 04.07.2019 18:10, agpraga23ovv65c
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
image
Engineering, 04.07.2019 18:10, soreese02
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Do you know the correct answer?
A four-pole induction machine with following parameters is controlled in the rotor flux linkage-orie...

Questions in other subjects:

Konu
Chemistry, 10.10.2020 19:01