Engineering, 05.05.2020 08:04, bubster5820

Suppose a computer has bytes of byte-addressable main memory and a cache size of bytes, and each cache block contains 32 bytes.

c) If this cache is direct-mapped, what is the format of a memory address as seen by the cache; that is, the size of the tag field , the size of block field , and the size of the offset field .
d) If this cache is fully associative, what is the format of a memory address as seen by the cache; that is, the size of the tag field , and the size of the offset field .
e) If this cache is 4-way set associative, what is the format of a memory address as seen by the cache; that is, the size of the tag field , the size of set field , and the size of the offset field .

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Do you know the correct answer?

Suppose a computer has bytes of byte-addressable main memory and a cache size of bytes, and each cac...