Engineering, 05.05.2020 19:21, tmrsavage02p7cj16

You have designed a bone plate that is manufactured via rolling under cold working conditions, and tests show good biocompatibility results for the device. The Manufacturing Department has put in a request to change the processing method to rolling under hot working conditions, in an effort to reduce the total manufacturing cost. Since the material from which the device is fabricated will not change, do you need to rerun the biocompatibility tests? Why or why not? (10 points)

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 04.07.2019 18:10, viicborella

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Do you know the correct answer?

You have designed a bone plate that is manufactured via rolling under cold working conditions, and t...