Engineering
Engineering, 05.05.2020 19:01, bbahena46

In one of her experiments, she used a binary mixture of n-pentane (density 39.1 lbm/ft^3) and p-xylene (density 53.8 lbm/ft^3). One outlet stream of her condenser was measured to have a flow rate of 37 ft^3/min and a concentration of 30/70 n-pentane/p-xylene by volume. The other outlet stream was measured to have a flow rate of 22 ft^3/min and a concentration of 50/50 n-pentane/p-xylene by volume. If the system operates at steady state and the only inlet to her condenser has a flow rate of 59 ft^3/min, what is the inlet concentration of n-pentane in % by volume?Your answer should be between 0 and 100. Round your answer to 1 decimal place for entry into eCampus. Do not enter units. Example: 12.3

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:20, CelesteN64
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
Do you know the correct answer?
In one of her experiments, she used a binary mixture of n-pentane (density 39.1 lbm/ft^3) and p-xyle...

Questions in other subjects:

Konu
Mathematics, 05.04.2021 05:10
Konu
Chemistry, 05.04.2021 05:10
Konu
Computers and Technology, 05.04.2021 05:10