Simulate the circuit using LogicWorks software.
Simplified elevator design problem: If t...
Engineering, 06.05.2020 00:13, meababy2009ow9ewa
Simulate the circuit using LogicWorks software.
Simplified elevator design problem: If the elevator is on floor m (for m ≥ 0) and the floor requested is floor m, then the elevator remains on floor m. If the elevator is on floor m and the floor requested is floor m + i, (for i > 0), the elevator moves up to floor m+i. If the elevator is on floor m and the floor requested is floor m - i (for i > 0), then the elevator moves to floor m-i.
Simulate and design an L-floor elevator controller according to the above description. Build it using your boards and chips. You may use
1. The switches to generate the floor request signals.
2. LEDs to indicate the up or down movement of the elevator.
3. One 7 segment display/driver board to display how many floors the elevator moves; or both displays to indicate the request and the position of elevator. Make any appropriate assumptions, and specify exactly how the switches should be set to initialize the circuit (if necessary) and to move the elevator from one floor to another.
Answers: 1
Engineering, 04.07.2019 18:10, lerasteidl
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1