Engineering
Engineering, 06.05.2020 00:06, oliviaberta91

Complete swap_bits function which swaps bits at odd and even positions of an integer (32 bits). In other words, every even position bit is swapped with the adjacent bit on the right side, and every odd position bit is swapped with the adjacent on the left side. For instance, bits 0 and 1 are swapped, bits 2 and 3 are swapped, and so on. It is not recommended to use loops or conditional statements for this part. Example: if the given number is 23 (00010111), it should be converted to 43 (00101011). Note this example, we only use the lower 8 bits of a number, but your program will work on 32-bit numbers. You can expect the input to your function in register $t0. The result must be stored inside $t0 as well.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, viicborella
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Do you know the correct answer?
Complete swap_bits function which swaps bits at odd and even positions of an integer (32 bits). In o...

Questions in other subjects:

Konu
Mathematics, 26.07.2021 16:00