Engineering, 06.05.2020 06:31, daytonalive83481

Water is to be cooled by passing through the tube in an insulated cross-flow heat exchanger, while air flows over the outside surface of the tube. The water enters the 4.0-cm-diameter pipe with a velocity of 15 m/s, a temperature of 150°C, and a quality of 0.10. The water exits as a liquid at 100°C (This can be approximated as a saturated liquid at 100°C.) The air enters the heat exchanger at 15°C.

a. For a mass flow rate of the air of 5.0 kg/s, determine the air exit temperature. You may use specific heats for calculating the enthalpy changes of air. (neglect the differences in potential and kinetic energies).
b. Using your heat exchanger model to acquire the data, plot the exit temperature of the air as the air mass flow rate varies from 4.0 kg/s to 25 kg/s.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Do you know the correct answer?

Water is to be cooled by passing through the tube in an insulated cross-flow heat exchanger, while a...