Engineering, 06.05.2020 08:34, haileyhale5

A member of a loaded truss is cut by an imaginary plane as indicated below. If the cross sectionalarea is 10 in2, the magnitude of the force is 100 kips and the orientation of the angle is 45❦from thex axis, determine the following information:(a) Determine ϝxx, ϝyyand ϝxyat point A.(b) Plot Mohrcircle for the stress state at point A.(c) Find the principal stresses and the maximum in-plane shear stress.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

Engineering, 04.07.2019 19:20, GusGus11

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

continue

Do you know the correct answer?

A member of a loaded truss is cut by an imaginary plane as indicated below. If the cross sectionalar...