Engineering, 26.04.2020 11:45, robsantana11

A wheel is used to turn a valve stem on a water valve. The wheel radius is 4 inches and the axle radius is .25 inches.

a. What is the mechanical advantage of the wheel and axle?

b. How much resistance force can be overcome when an effort of 6 lbs is applied to the wheel of the water valve in this problem?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Engineering, 04.07.2019 19:10, justkevin1231

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

continue

Engineering, 04.07.2019 19:10, brid7931

Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates

Answers: 3

continue

Engineering, 04.07.2019 19:10, lexie223

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

continue

Do you know the correct answer?

A wheel is used to turn a valve stem on a water valve. The wheel radius is 4 inches and the axle rad...