Engineering
Engineering, 25.04.2020 02:06, tajanae11

A 35° API distillate at 60 °F is to be pumped a distance of 2,000 ft through a 4 inch schedule 40 horizontal pipeline at a flow rate of 500 gpm. What power must the pump deliver to the fluid if the pipeline is made of (a) plastic drawn tubing; (b) commercial steel (light rust); (c) galvanized iron? Assume the pipe is horizontal, and that P1 = P2.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, mamasbug4285
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
image
Engineering, 06.07.2019 03:10, cchotshot
Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg. a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg. m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?
Answers: 1
image
Engineering, 06.07.2019 03:20, demotte79991
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
image
Engineering, 06.07.2019 04:10, idjfjcjs584
Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg. k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft
Answers: 1
Do you know the correct answer?
A 35° API distillate at 60 °F is to be pumped a distance of 2,000 ft through a 4 inch schedule 40 ho...

Questions in other subjects:

Konu
Mathematics, 15.01.2022 15:00
Konu
Biology, 15.01.2022 15:00
Konu
Mathematics, 15.01.2022 15:00