Engineering, 25.04.2020 01:02, kydog00

A steel part is loaded with a combination of bending, axial, and torsion such that the following stresses are created at a particular location:

Bending: Completely reversed, with a maximum stress of 60 MPa

Axial: Constant stress of 20 MPa Torsion Repeated load, varying from 0 MPa to 70 MPa

Assume the varying stresses are in phase with each other.

The part contains a notch such that Kbending 14, Kaial 1.1, and Kmesion= 2.0. The material properties are 400 MPa. The completely adjusted endurance limit is found to be S 160 MPa.

а. Find the factor of safety for fatigue based on infinite life, using the Goodman criterion.

b. If the life is not infinite, estimate the number of cycles, using the Walker criterion to find the equivalent completely reversed stress. Be sure to check = = 300 MPa and S for yielding.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:20, jessie8022

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

continue

Do you know the correct answer?

A steel part is loaded with a combination of bending, axial, and torsion such that the following str...