Engineering
Engineering, 24.04.2020 16:24, treypickich14

From 2011-2015, California experienced an extreme drought. According to some paleoclimatologists, this drought was the most severe in the past 1200 years. Because water use for thermoelectric power generation is one of the largest uses of water world-wide, one means of reducing water use in California is shifting electricity generation to systems that consume less water. Although California imports much of the electricity it uses from other states, there is still a substantial amount of electricity generation that is done in-state, and this offers opportunities for water conservation.
a) Using the data provided in the Table below, estimate total water usage associated with electricity generation in California. Identify the type of electricity generation that uses the most water per MWhr and the type of electricity generation that uses the largest total amount of water.
b) If all electricity generation in California were to switch to natural gas and the water intensity of electricity generation (I water/MWh) remained the same, how much would water usage be reduced?
c) If the average municipal water use is 100 gal per person per day (36,500 gal/yr), how many people could be provided with water with the savings identified in part b? (1 gal = 3.81)
Fuel source Water used in extracting fuel Water used in generating electricity Electricity generated in California
- (liters of water per MWhr of elecetricity generated) (liters of water per MWhr of elecetricity generated) (MWhr)
Natural gas 24 737 76,082,000
Coal 96 1895 3,692,000
Nuclear 212 1817 36,586,000
Wind 0 4 2,418,000
Thermal Solar Source: 0 3975 681,000

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
image
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
image
Engineering, 04.07.2019 18:20, rjone8429
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Do you know the correct answer?
From 2011-2015, California experienced an extreme drought. According to some paleoclimatologists, th...

Questions in other subjects:

Konu
Business, 04.03.2021 16:30
Konu
Mathematics, 04.03.2021 16:30