Engineering, 22.04.2020 02:10, krojas015

Water at 58C is being used to cool apples from an initial temperature of 208 to 88C. The water flow over the surface of the apple creates a convective heat-transfer coefficient of 10 W/(m2 K). Assume the apple can be described as a sphere with an 8-cm diameter and the geometric center is to be reduced to 88C. The apple properties include thermal conductivity of 0.4 W/(m K), specific heat of 3.8 kJ/(kg K), 3 and density of 960 kg/m . Determine the time that the apples must be exposed to the water.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:20, CelesteN64

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Do you know the correct answer?

Water at 58C is being used to cool apples from an initial temperature of 208 to 88C. The water flow...