Engineering
Engineering, 21.04.2020 17:46, chony83

Consider a refrigeration truck traveling at 55 mph at a location where the airtemperature is 80F. The refrigerated compartment of the truck can be considered to the a 9-ft-wide,8-ft-high, and 20-ft-long rectangular box. The refrigeration system of the truck removes heat at arate of 600 Btu/min. The outer surface of the truck is coated with a low-emissivity material, andthus radiation heat transfer is very small. Determine the averagetemperature of the outer surface ofthe refrigeration compartment of the truck. Assume the air flow over the entire outer surface to beturbulent, and the heat transfer coefficient at the front and rear surfaces to be equal to that on sidesurfaces.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, colin774
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
image
Engineering, 04.07.2019 18:10, salazjlove
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
image
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
Do you know the correct answer?
Consider a refrigeration truck traveling at 55 mph at a location where the airtemperature is 80F. T...

Questions in other subjects:

Konu
Social Studies, 11.09.2020 15:01
Konu
Mathematics, 11.09.2020 15:01
Konu
English, 11.09.2020 15:01
Konu
Mathematics, 11.09.2020 15:01
Konu
Mathematics, 11.09.2020 15:01
Konu
Mathematics, 11.09.2020 15:01
Konu
Biology, 11.09.2020 15:01
Konu
Mathematics, 11.09.2020 15:01
Konu
Social Studies, 11.09.2020 15:01
Konu
Mathematics, 11.09.2020 15:01