Engineering, 21.04.2020 15:28, glocurlsprinces

For beam design, the cross section dimensions of the beam are determined: A. Based on allowable normal stress, but the allowable shear stress should always be checked to be sure it is not exceeded. B. Based on the allowable shear stress, but the allowable normal stress should always be checked to be sure it is not exceeded. C. Such that both the allowable normal stress and the allowable shear stress are reached at the same time. D. Based on the allowable normal stress. E. The allowable shear stress is not an important design consideration.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, heidiburgos1own6c0

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Do you know the correct answer?

For beam design, the cross section dimensions of the beam are determined: A. Based on allowable norm...