Engineering
Engineering, 20.04.2020 19:40, thisismyusername875

A small vehicle is powered by a pulsejet. The available net thrust is 6000 N and the traveling speed is 200 km/hr. The gases leave the engine with an average velocity (Ve) of 360 m/s Assume pressure equilibrium exists at the outlet plane and the fuel to air ratio is 0.06.

a. Compute the mass flow rate required
b. Calculate the inlet area (assume To is 16 °C and Po is one atmosphere)
C. Calculate the thrust power
d. Calculate the propulsive efficiency

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, Arealbot
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, selenamr
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
image
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Do you know the correct answer?
A small vehicle is powered by a pulsejet. The available net thrust is 6000 N and the traveling speed...

Questions in other subjects: