Engineering, 18.04.2020 00:44, sugardime
Engineers are considering two possible vessel shapes for storing fuel. One shape is cylindrical and the other is spherical. Each vessel would be constructed out of the same material such that its hoop stresses and longitudinal stresses would be no greater than 17.0 ksi . The cylindrical pressure vessel has an inside diameter of dc = 30.0 in and a thickness of tc = 1.00 in . The spherical pressure vessel has an inside diameter of ds = 29.0 n and a thickness of a = 0.250 in .
Determine the maximum allowable pressure, pc, max, in the cylindrical pressure vessel.?Determine the maximum allowable pressure, ps, max, in the spherical pressure vessel.?
Determine the required thickness of the cylindrical pressure vessel, tr, if it is subjected to the maximum allowable pressure of the spherical pressure vessel.
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10, hadellolo8839
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 19:20, GusGus11
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
Do you know the correct answer?
Engineers are considering two possible vessel shapes for storing fuel. One shape is cylindrical and...
Questions in other subjects:
Biology, 17.03.2020 03:35
