Engineering, 17.04.2020 18:48, nesa10
Consider a single crystal of some hypothetical metal that has the FCC crystal structure, and its critical resolved shear stress is 3.42 MPa. The crystal is oriented such that a tensile stress is applied at an angle of 39.2 degrees to the slip plane. Slip can occur in two directions( 18.4 and 74.2 degrees to the tensile force).
a. Which direction, is slip favored?
b. What is the yield strength of this crystal during this tensile test?
Answers: 3
Engineering, 04.07.2019 18:10, yasminothman02
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Consider a single crystal of some hypothetical metal that has the FCC crystal structure, and its cri...
Mathematics, 31.08.2021 03:00
Mathematics, 31.08.2021 03:00
Mathematics, 31.08.2021 03:00
History, 31.08.2021 03:00