Engineering
Engineering, 17.04.2020 14:49, 19cmulett

4. Determine the Zener potential when the
temperature changes from 25 degrees to 100
degrees, where
V (25) = 9V, Fe = 0.065%/ °C

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, yasyyas646646
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 06.07.2019 04:10, neariah24
An array of m-50 thermoelectric modules is installed on the exhaust of a sports car. each module has an effective seebeck coefficient of sp of 0.143 5vk and an internal electrical resistance of r.-4 ? in addition, : (15 points each module is of width w 60mm and contains n=100 pairs of semiconducting pellets. each pellet hasan overall length of 2l-5mm and a cross-sectional area as 1.2 x 10'm and is characterized by a thermal conductivity of kpl2w rnk. the hot side of each module is exposed to exhaust gases at·p650c with hia4ow rrk while the osite side of each module is cooled by pressurized water at surface) and 156 °c (at the cool surface). 11s c with h: -500w/m'k. the modules are wired n series and the load resistance is r d=400ohm .the module surface temperatures, t, and ts are 183 "c (at the hot surface and 156c (at the cool surface) a)-draw a schematic of this scenario and label all parts. a. b. if the induced current, i, is 0.15 amps, what is the total power (pa) for one module? c. what is the total power harvest from the exhaust with all 50 modules?
Answers: 2
image
Engineering, 06.07.2019 04:20, hailiemanuel930
Steam enters a turbine at steady state at 2 mpa, 360°c with a velocity of 100 m/s. saturated vapor exits at 0.1 mpa and a velocity of 50 m/s. the elevation of the inlet is 3 m higher than at the exit. the mass flow rate of the steam is 15 kg/s, and the power developed is 7 mw. let g 9.81 m/s^2. determine: a)-the area at the inlet, in m^2 b)-the rate of heat transfer between the turbine and surroundings, in kw c)-draw a p-v diagram for this process.
Answers: 1
Do you know the correct answer?
4. Determine the Zener potential when the
temperature changes from 25 degrees to 100
degre...

Questions in other subjects:

Konu
Mathematics, 20.04.2020 01:58