Engineering
Engineering, 17.04.2020 04:33, shongmadi77

From the following numbered list of mechanical characteristics, decide which pertain to (a) the matrix phase, and which are displayed by (b) the dispersed phase for fiber-reinforced composites. (1) Stiff (2) Relatively weak (3) Low elastic modulus (4) Brittle (5) Quite ductile (6) Quite strong (a) - 2,5 (b) - 1,3,4 (a) - 2 (b) - 1,4 (a) - 2,3,5 (b) - 1,4,6 (a) - 1,4,6 (b) - 3,5 Click if you would like to Show Work for this question: Open Show Work

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
image
Engineering, 04.07.2019 19:10, nbunny7208
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
image
Engineering, 04.07.2019 19:10, juneham
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Do you know the correct answer?
From the following numbered list of mechanical characteristics, decide which pertain to (a) the matr...

Questions in other subjects:

Konu
Mathematics, 27.01.2021 09:00