Engineering, 17.04.2020 00:15, joe1591
A concentrated load P is applied to the upper end of a 1.38-m-long pipe. The outside diameter of the pipe is D = 116 mm and the inside diameter is d = 104 mm.(a) Compute the value of Q for the pipe.(b) If the allowable shear stress for the pipe shape is 77 MPa, determine the maximum load P that can be applied to the cantilever beam.
Answers: 2
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
A concentrated load P is applied to the upper end of a 1.38-m-long pipe. The outside diameter of the...
Social Studies, 08.03.2021 23:50
Mathematics, 08.03.2021 23:50
Mathematics, 08.03.2021 23:50
Social Studies, 08.03.2021 23:50
Chemistry, 08.03.2021 23:50
Mathematics, 08.03.2021 23:50
Mathematics, 08.03.2021 23:50