Engineering, 16.04.2020 21:21, cork6

Assume that a surface-grinding operation is being carried out under the following conditions: D = 250 mm D=250 mm, d = 0.4 mm d=0.4 mm, v = 0.5 m / s v=0.5 m/s, and V = 50 m / s V=50 m/s. These conditions are then changed to the following: D = 150 mm D=150 mm, d = 0.4 mm d=0.4 mm, v = 0.3 m / s v=0.3 m/s, and V = 25 m / s V=25 m/s. What is the difference in the temperature rise from the initial condition?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:10, brid7931

Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates

Answers: 3

continue

Engineering, 04.07.2019 19:20, zoebtharpe

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

continue

Engineering, 04.07.2019 19:20, nikkiebartels

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer, e = 5 × 105?

Answers: 2

continue

Do you know the correct answer?

Assume that a surface-grinding operation is being carried out under the following conditions: D = 25...