Engineering, 16.04.2020 18:23, melaniegilbreath

The following equation is used to calculate the heat transfer Q in a boiler given the surface area A, the overall heat transfer coefficient U, the heating fluid inlet temperature T1, the heating fluid exit temperature T2, and the temperature of the boiling fluid Ts. Let T1 = 600 o F, Ts = 535 o F, and Q/(UA) = 34.1 o F. a. Show that a root exists between T2 = 536 o F and T2 = 580 o F. (Do not find the actual root yet.) b. Write a MATLAB program

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 19:10, LadyHolmes67

Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false

Answers: 3

continue

Engineering, 06.07.2019 03:10, lacourboud20005

An electrical kettle is made out of stainless steel, weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.

Answers: 1

continue

Engineering, 06.07.2019 04:10, idjfjcjs584

Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg. k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft

Answers: 1

continue

Engineering, 06.07.2019 04:20, smokemicpot

Assume that you are asked to perform a boring operation on a large-diameter hollow workpiece. would you use a horizontal or a vertical boring mill?

Answers: 3

continue

Do you know the correct answer?

The following equation is used to calculate the heat transfer Q in a boiler given the surface area A...