Engineering, 16.04.2020 18:39, tydukes10

3. A full journal bearing has a journal diameter of 3 in. The bushing bore has a diameter of 3.005 in. The bushing is 1.5 in long. The load is 800 lbf and the journal runs at 600 rev/min. For (a) SAE 10 and (b) SAE 40 lubricants, find the minimum film thickness and the maximum film pressure for an operating temperatures of 150°F for the minimum clearance assembly.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, viicborella

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Do you know the correct answer?

3. A full journal bearing has a journal diameter of 3 in. The bushing bore has a diameter of 3.005 i...