Engineering
Engineering, 16.04.2020 04:56, mrblake1594

Design Your speaker has two acoustic drivers, a woofer (low frequencies) and a tweeter (high frequencies). The impedance of the woofer looks like the series connection of a 10Ω resistance and a 1.2mH inductance (the speaker coil). The tweeter looks like the series connection of a 12Ω resistance and a 10uH inductance. Explain why we can ignore the inductance of the tweeter in our crossover design, but not the inductance of the woofer. Since your crossover filter would like to see a constant resistive impedance, design a Zobel Network to compensate the woofer so that it looks like a constant 100 from 20Hz to 20kHz. Show your calculations below and a schematic of the compensated woofer.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 03:10, lauriepdx17
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
image
Engineering, 04.07.2019 18:10, mm016281
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
image
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
image
Engineering, 04.07.2019 18:10, mirmir62
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
Do you know the correct answer?
Design Your speaker has two acoustic drivers, a woofer (low frequencies) and a tweeter (high frequen...

Questions in other subjects:

Konu
Mathematics, 25.02.2020 18:23
Konu
Mathematics, 25.02.2020 18:23