Engineering, 16.04.2020 00:47, sairaanwar67

The following information is available for a seeded 5-day BOD test conducted on a wastewater sample. 15 mL of the waste sample was added directly into a 300-mL BOD incubation bottle and then 285 mL of dilution water was added to fill the bottle. The initial DO of the diluted sample was 8.8 mg/L and the final DO after 5 days was 1.9 mg/L. 1. Assuming that the BOD5 of 285 mL dilution water is 0 mg/L. What is the 5-day BOD (BOD5) of the wastewater sample 2. In reality, the dilution water usually has its own BOD. In a control experiment of determining the BOD5 of dilution water with seed microorganisms, the initial DO of dilution water was 9.1 mg/L and the final DO after 5 days was 7.9 mg/L. What is the 5-day BOD (BOD5) of the wastewater sample

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Engineering, 04.07.2019 18:20, sanchez626

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

Engineering, 04.07.2019 19:10, nhester3401

Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.

Answers: 2

continue

Do you know the correct answer?

The following information is available for a seeded 5-day BOD test conducted on a wastewater sample....