Engineering, 14.04.2020 23:21, nnyahtoland

For a solid-state transformation that obeys the Avrami equation, the parameter n has been determined to have a value of 1.5. The reaction takes 125 seconds to reach 30% completion. What is the total time (in seconds) for the transformation to reach 95% completion

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Do you know the correct answer?

For a solid-state transformation that obeys the Avrami equation, the parameter n has been determined...