Engineering, 14.04.2020 19:07, thall5026

The axle of an automobile is acted upon by the forces and coupleshown. Knowing that the diameter of the solid axle is 32 mm, determine(a) the principal planes and principal stresses at point H locatedon top of the axle, (b) the maximum shearing stress at the same point.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 19:10, moneyyfletcher

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

continue

Engineering, 04.07.2019 19:20, qurreab26

A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.

Answers: 1

continue

Engineering, 06.07.2019 05:10, squawk1738

The ivanpah solar thermal power plant cost $2.2 billion to build. the gross plant electric output is 392 mw, and the net output is 377 mw. the planned capacity factor was 27.4%, but the actual capacity factor in 2016 was 20.5%. at best the plant thermal efficiency appears to be 18%. in addition, for the daily startup process, the solar plant also burned 1.3x10^12 btu of natural gas in 2016. the cost of natural gas in 2016 was about $2.5 per million btu. assuming a levelized annual fixed charge rate of 7%, determine (a) the capital cost (c/kwh) and (b) the fuel cost (e/k wh) for the electricity in 2016.

Answers: 3

continue

Engineering, 06.07.2019 05:20, miguelperdomo

Calculate the angle of incidence of beam radiation on a surface located at glasgow (56°n, 4°w) at 10 a. m. on 1 february, if the surface is oriented 20° east of south and tilted at 40° to the horizontal

Answers: 1

continue

Do you know the correct answer?

The axle of an automobile is acted upon by the forces and coupleshown. Knowing that the diameter of...