Engineering, 08.04.2020 23:46, kkcheers16

Using the example above, you need to write the actual problem statement for the problem presented below, which would be the part that begins with: “The goal of this project is…”
Then, you are going to determine 5 “customer needs” that must be considered for anyone trying to come up with a solution to the mosquito problem below.

Design Problem: - Non-Chemical way to Kill Mosquitoes in swamps
Problem Description:
Here in South Carolina, Mosquitoes are a nuisance because of the prevalence of standing water in swamps. While it is possible to use chemicals to treat the water and kill the mosquito larvae, these chemicals have been found to kill bees, which are essential to farms and are rapidly becoming an endangered species. The goal of this project is .

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, mirmir62

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

Do you know the correct answer?

Using the example above, you need to write the actual problem statement for the problem presented be...