Engineering, 08.04.2020 03:14, MK100

A storm hits a small (15 km2) catchment and runoff is generated. You have been given a time series (see below; the picture is also stored in the files folder) of precipitation input and stream flow. You may assume that ET during this time is negligible and that there is no change in canopy storage. About 2.2 cm of input water is stored in depressions and as soil moisture. Required: (a) Plot a simultaneous hyeto-hydrograph of the event, to scale, on engineering paper. Include dual vertical axes, with units. Label and scale all axes. (b) Use a graphical method to separate the hydrograph. Label the event flow and baseflow. Show your work, indicating the method you chose and steps taken to separate the hydrograph. (c) Compute p/P (d) Compute Q

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

Engineering, 04.07.2019 19:10, ultimateapes

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

continue

Do you know the correct answer?

A storm hits a small (15 km2) catchment and runoff is generated. You have been given a time series (...