Engineering
Engineering, 07.04.2020 21:43, kehlani315242

Bothersome feature of many physical measurements is the presence of a background signal (commonly called "noise"). In Part 2.2.4 of the experiment, some light that reflects off the apparatus or from neighboring stations strikes the photometer even when the direct beam is blocked. In addition, due to electronic drifts, the photometer does not generally read 0.0 mV even in a dark room. It is necessary, therefore, to subtract off this background level from the data to obtain a valid measurement. Suppose the measured background level is 5.1 mV. A signal of 20.7 mV is measured at a distance of 29 mm and 15.8 mV is measured at 32.5 mm. Correct the data for background and normalize the data to the maximum value. What is the normalized corrected value at 32.5 mm

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
image
Engineering, 04.07.2019 18:10, winterblanco
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
image
Engineering, 04.07.2019 18:20, yasyyas646646
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
Do you know the correct answer?
Bothersome feature of many physical measurements is the presence of a background signal (commonly ca...

Questions in other subjects:

Konu
Mathematics, 05.05.2020 06:50
Konu
Social Studies, 05.05.2020 06:50
Konu
Mathematics, 05.05.2020 06:50