Engineering
Engineering, 07.04.2020 16:20, tinaxiao

You are given the 500-mb heights and absolute vorticity maps at 12Z on December 31. You are also given near-surface temperatures (40 meters above the ground) for the same time.

12Z 12/31 500-mb Heights
12Z 12/31 500-mb Abs. Vorticity
12Z 12/31 40m Temperature

At the time the seed of the snowstorm started to sprout, there was a potent short-wave trough at 500 mb associated with a powerful surface low-pressure system that was moving away from the coast of Maine. There was also a short-wave trough at 500 mb over the upper Middle West associated with an "Alberta Clipper", which is a modest surface low-pressure system that usually brings only a nuisance snow along and north of its path. The reason I mention these two systems is that I want to point you away from them. Just so you won't get confused -- neither one of these systemsserved as the catalyst for triggering the low-pressure system that ultimately dumped heavy snow in eastern Pennsylvania. In other words, ignore these two short-wave troughs!

At this time a weak surface low has just formed. Complete the following statement: The newly formed surface low is located at approximately N W (latitude/longitude... ex. "36N 70W") and (relative location... ex. "east/west", "upstream/downstream", etc ) of the 500-mb short wave trough axis. Note: A range of values will of course be accepted for the longitude/latitude estimate of the surface low's position.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, Arealbot
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
Do you know the correct answer?
You are given the 500-mb heights and absolute vorticity maps at 12Z on December 31. You are also giv...

Questions in other subjects:

Konu
Social Studies, 23.09.2020 17:01