Engineering
Engineering, 07.04.2020 00:19, paisley13

Identify the following statements as True or False?

1. Copper has a higher thermal conductivity than aluminum.
2. The density of copper is closer to that of aluminum than it is to iron.
3. Bronze alloys with more than 20 wt% tin are quite ductile and easily cold-worked compared to alloys with 5 wt% tin or less, because large additions of the soft metal tin enhance the ductility of copper.
4. Copper and its alloys form a green tarnish over time, consisting of sulfides and carbonates.
5. The electrical conductivity of somewhat impure copper alloys can actually be increased by introducing a small amount of oxygen into the copper, provided the oxygen reacts with impurities and coalesces them into larger oxide particles.
6. Copper is relatively resistant to corrosion by neutral and even mildly basic water.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
image
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
image
Engineering, 04.07.2019 18:10, mamasbug4285
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Do you know the correct answer?
Identify the following statements as True or False?

1. Copper has a higher thermal cond...

Questions in other subjects:

Konu
Mathematics, 21.04.2020 18:58