Engineering, 04.04.2020 11:12, stodd9503

A square power screw has a mean diameter of 30 mm and a pitch of 4 mm with single thread. The collar diameter can be assumed to be 35 mm. The screw is to be used to lift and lower a load of 7 kN. A coefficient of friction of 0.05 is to be used for friction at the thread and at the collar. Determine the following: (i) Torque required to raise the load, TR, (Equation 8.1) (ii) Torque required to lower the load, TL, (Equation 8.2) (iii) A conservative estimate of self locking condition is to set TL in equation 8.2 to zero and calculate the minimum coefficient of friction to ensure self locking. What is the minimum coefficient of friction to ensure self locking

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:10, justkevin1231

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

continue

Do you know the correct answer?

A square power screw has a mean diameter of 30 mm and a pitch of 4 mm with single thread. The collar...