Engineering
Engineering, 31.03.2020 21:47, jetblackcap

A factory requires at least 4 Mgal/day more water than it is currently using. A water supply facility can supply up to 10 Mgal/day of additional water with a BOD of 50mg/L, and a local stream can supply an additional 2 Mgal/day with a BOD of 200 mg/L. After use, the factory discharges the water is used to a local river. The concentration of biochemical oxygen demand (BOD) in the wastewater released to a nearby river must be less than 100mg/L. The cost of water is $1000/Mgal from the water supply facility and $150/Mgal from the local stream. The factory has obtained financing that allows them to spend no more than $3500/day on water.
a. Formulate a systems model and find the minimum cost solution that satisfies all constraints.
b. Then, reformulate the model for minimum discharge BOD solution that satisfies all constraints.
c. Plot the two solutions to the previous problem on a graph that has cost on the horizontal axis and BOD on the vertical axis. Draw a line connecting these two different optima and determine the slope of that line.
d. Propose a new environmental policy that would cause a profit-maximizing factory manager to put in place the BOD-minimizing design.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 03.07.2019 19:30, 10040813
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
image
Engineering, 04.07.2019 18:10, Fahaddie
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
image
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Do you know the correct answer?
A factory requires at least 4 Mgal/day more water than it is currently using. A water supply facilit...

Questions in other subjects:

Konu
Mathematics, 20.09.2020 19:01
Konu
Chemistry, 20.09.2020 19:01