Engineering, 31.03.2020 02:26, carlydays4403

A balanced three phase source is supplying a balanced three phase load through a transmission line with impedance of 10+j30 ohm per phase. Load is consuming 300 MW at power factor of 0.8 lagging. Load voltage (line-line) is held constant at kV. Frequency is 60 Hz. 1. Find the real power lost in the line. 2. By adding capacitors power factor is improved to one (unity power factor) find the real power lost in the line.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, qwertylol12345

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Do you know the correct answer?

A balanced three phase source is supplying a balanced three phase load through a transmission line w...