Engineering, 30.03.2020 21:29, mac7210

Use sig_noise to generate a 256-point waveform consisting of a 300-Hz sine wave with an SNR of −12 dB (x=sig_noise(300, −12,256); ). Calculate and plot the power spectrum using 2 different approaches. First use the direct approach: take the Fourier transform and square the magnitude function. In the second approach use the traditional method defined by Equation 4.11: take the Fourier transform of the autocorrelation function. Calculate the autocorrelation function using axcor, then take the absolute value of the fft of the autocorrelation function. You should only use the second half of the autocorrelation'

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:20, cxttiemsp021

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

continue

Engineering, 04.07.2019 19:10, lexie223

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

continue

Engineering, 06.07.2019 02:30, khalilh1206

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

continue

Do you know the correct answer?

Use sig_noise to generate a 256-point waveform consisting of a 300-Hz sine wave with an SNR of −12 d...