Engineering, 30.03.2020 21:00, sswaqqin

Design a full-wave bridge rectifier to supply 12V DC voltage to a resistive load of RL=3Ω at the output, assuming an AC supply with 60 Hz frequency with the following characteristics: a) Unfiltered (without output capacitor) b) Filtered. Design a filter capacitor so that the ripple factor of the output voltage is less than %5. Regularly if you add a filter capacitor, the average output voltage would increase. You should revise the AC supply peak voltage VVmm calculated in (a) to match the average 12V DC requirement. Find and report the final value of VV�

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, jesuslovesusall3

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

continue

Engineering, 04.07.2019 18:20, sarah7984

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

continue

Do you know the correct answer?

Design a full-wave bridge rectifier to supply 12V DC voltage to a resistive load of RL=3Ω at the out...