Engineering, 28.03.2020 04:41, jose477

Steam enters a heat exchanger at a pressure of 1.5 bar and a temperature of 400°C with a mass flow rate of 0.05 kg/s and exits at a temperature of 120°C and at the same inlet pressure. The steam heat transfer takes place with refrigerant R22 in a separate stream. The refrigerant enters the heat exchanger as liquid at 4.5 bar and leaves at the same pressure and at a temperature of 10°C. The heat exchanger is not well designed and there is stray heat transfer to the surroundings equal to 10% of the heat transferred from the steam.

Determine

(a) The rate of stray heat transfer, in kW.

(b) The rate of heat transfer to the refrigerant, in kW

(c) The mass flow rate of the refrigerant, in kg/s

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:10, kayleeemerson77

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

continue

Do you know the correct answer?

Steam enters a heat exchanger at a pressure of 1.5 bar and a temperature of 400°C with a mass flow r...