Engineering, 28.03.2020 04:02, 22chandlerlashley

A simple medium access control protocol would be to use a fixed assignment time division multiplexing (TDM) scheme. Each station is assigned one time slot per cycle for transmission. For the bus, the length of each slot is the time to transmit 100 bits plus the ene-to-end propagation delay. For the ring, assume a delay of 1 bit time per station, and assume that a round-robin assignment is used. Stations monitor all time slots for reception.

Assume a propagation time of 2×108 m/s. For N stations, what is the throughput per station for :

a. A 1-Km, 10 Mbps baseband bus

b. A 10-Mbps ring with a total length of 1Km

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:20, CelesteN64

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

Engineering, 04.07.2019 19:20, natalie2sheffield

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

continue

Do you know the correct answer?

A simple medium access control protocol would be to use a fixed assignment time division multiplexin...