Engineering, 27.03.2020 21:48, biba54

A shaft is loaded in bending and torsion such that Ma = 35 N · m, Ta = 40 N · m, Mm = 45 N · m, and Tm = 15 N · m. For the shaft, Su = 600 MPa and Sy = 420 MPa, and a fully corrected endurance limit of Se = 190 MPa is assumed. Let Kf = 2.1 and Kfs = 1.7. With a design factor of 2.0 determine the minimum acceptable diameter of the shaft using the

(a) DE-Gerber criterion.
(b) DE-ASME Elliptic criterion.
(c) DE-Soderberg criterion.
(d) DE-Goodman criterion.
Discuss and compare the results.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

Engineering, 04.07.2019 18:20, annette211pdd8v9

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

continue

Engineering, 04.07.2019 18:20, sanchez626

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

continue

Engineering, 04.07.2019 19:10, Calliedevore

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

continue

Do you know the correct answer?

A shaft is loaded in bending and torsion such that Ma = 35 N · m, Ta = 40 N · m, Mm = 45 N · m, and...