Engineering, 25.03.2020 22:29, nestergurl101

A non-inverting amplifier has a feedback resistor of 10 kohms aAssuming rail-to-rail output voltage swing and TYPICAL output current limit as specified in the op-amp datasheet, what will be the output voltage when a 4V input signal is applied to the circuitnd an input resistor of 5 kohms. It is connected to a load RL = 500 ohms. The amplifier is built using a LM741C op-amp powered from +12V and -8V supplies.

what will be the output voltage when a 4V input signal is applied to the circuit?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, selenamr

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Do you know the correct answer?

A non-inverting amplifier has a feedback resistor of 10 kohms aAssuming rail-to-rail output voltage...