Engineering, 24.03.2020 21:05, tfraz4412

Estimate the force required to upset a 5 mm diameter C74500 brass rivet in order to form a 10 mm diameter head. Assume that the coefficient of friction between the brass and the tool-steel die is 0.25 and that the head is 5 mm in thickness. Use S y = 175 Sy=175 MPa.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, Talos02

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

Do you know the correct answer?

Estimate the force required to upset a 5 mm diameter C74500 brass rivet in order to form a 10 mm dia...