Engineering, 24.03.2020 17:50, laya35

G bone is an anisotropic tissue that supports higher loads in the longitudinal direction, due to the high level of organization of collagen and hydroxyapatite. the elastic modulus of a femur was found to be 40 gpa when measured in the longitudinal direction, and can be modeled as a composite with continuous oriented fibers. the volume fraction of the hydroxyapatite inclusions is 50%. the moduli of the inclusions and matrix are 79 gpa and 1 gpa respectively. the femur has a radius of 3 cm. determine the necessary radius of bone with entirely isotropic mechanical properties (i. e. inclusions are random particles now). in both cases, bone should not exceed a strain of 1%

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, genyjoannerubiera

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

continue

Do you know the correct answer?

G bone is an anisotropic tissue that supports higher loads in the longitudinal direction, due to the...